Skip to content
Serving San Jose and nearby cities Open 24 hours, 7 days a week ยท (669) 800-1182

Heating Repair in Campbell, CA

The short answer

SwiftAir Conditioning Repair fixes gas furnaces and heat pumps in Campbell homes, from failed igniters and flame sensors to heat pumps blowing cool air. We find the cause and explain the repair before starting. We can also help you weigh repair against replacement under current Bay Area Air District rules.

Campbell winters are mild and damp rather than harsh, so many furnaces and heat pumps sit unused for months. Then the rainy season settles in, and they are asked to run every morning and evening. That on-off pattern is when problems tend to show up: a burner that won't light, a heat pump blowing lukewarm air, or a blower that hums but doesn't move. SwiftAir Conditioning Repair sends technicians from our San Jose base, about 8 miles away, to homes throughout Campbell and the 95008 ZIP code to find the cause and fix it.

Common Heating Problems in Campbell Homes

In the Santa Clara Valley, heating systems often sit idle from spring through fall. Over that time, dust settles on burners and sensors, filters get forgotten, and small electrical issues stay hidden until the first cold snap. When the system finally runs, those issues tend to surface all at once. These are the problems Campbell homeowners call us about most often:

If you smell gas, leave the house and call your gas utility or 911 from outside before calling anyone for repairs. A suspected gas leak is not something to troubleshoot yourself.

  • The furnace clicks or tries to start but never lights, often because of a dirty flame sensor or a failing igniter
  • The burners light, then shut off after a few seconds or minutes
  • The heat pump runs but blows cool or lukewarm air in heating mode
  • The blower motor hums, squeals, or won't turn on at all
  • Some rooms stay cold while others are comfortable
  • The thermostat calls for heat but nothing happens
  • A burning-dust smell lingers well past the first few minutes of the season

What Happens During a Heating Repair Visit

Our technician starts by asking what you've noticed: when the problem began, whether it's constant or comes and goes, and any noises or smells. Then they check the system in order. That means the thermostat, power and safety switches, filter, ignition, and burners or heat pump refrigerant circuit. It also includes the blower and the venting that carries exhaust out of the house.

Once we find the cause, we explain it in plain terms and tell you what the repair involves before any work starts. Many common fixes can be done on the first visit when the part is on the truck, such as cleaning or replacing a flame sensor, swapping an igniter, or replacing a failed capacitor. If a part has to be ordered, we tell you up front and leave the system in a safe condition in the meantime.

On gas furnaces, we also check for carbon monoxide risks. A cracked heat exchanger or blocked flue can push exhaust into living space. We inspect those components even when the original complaint is something else.

Repair or Replace? What Air District Rules Mean for You

Bay Area Air District rules are changing what happens when a gas furnace reaches the end of its life. Under Rule 9-4, natural gas furnaces manufactured from 2029 onward must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when a furnace is replaced after that date.

These rules do not require you to replace a furnace that still works. They apply only when existing equipment fails or is replaced. If your furnace can be repaired safely and at a reasonable cost, repairing it is a sound choice. We'll give you a straightforward assessment of its condition. Then you can decide whether a repair makes sense now or whether it's time to start planning for a heat pump.

If you're considering a heat pump, the federal Energy Efficient Home Improvement Credit (25C) is no longer an option. It covered only qualifying heat pumps placed in service before December 31, 2025, so it isn't available for new installations. Campbell homeowners can check BayREN and their local clean energy provider for current electrification incentives. Those amounts change with each funding cycle, so we confirm the current offer before including it in any quote.

Quick Checks Before You Call

A few checks take only a few minutes and sometimes solve the problem outright:

If none of these help, or the system keeps shutting itself off, it's time to call a technician. Repeatedly resetting a furnace that trips a safety limit can hide a bigger problem.

  • Make sure the thermostat is set to Heat with the setpoint above room temperature, and replace its batteries if it uses them
  • Check the breaker for the furnace or air handler, plus the on/off switch near the unit, which often looks like a regular light switch
  • Replace a dirty filter, since a clogged filter can make a furnace overheat and shut down
  • Confirm the furnace door panel is fully closed, because a safety switch keeps the unit from running if the panel is loose
  • For heat pumps, clear leaves and debris from around the outdoor unit

Heating Repair in Campbell and Nearby Communities

We repair gas furnaces, heat pumps, and the thermostats and ductwork connected to them in houses, townhomes, and condos across Campbell. Our technicians also serve nearby Monte Sereno, Los Gatos, Saratoga, Cupertino, and Santa Clara. If you have family or a rental property in one of those communities, the same team can help there too.

More services in Campbell

Related

What to expect

How a visit goes

  1. Clear answers before work begins

    We show you what's wrong, explain your options, and let you decide. Work starts after you approve it.

  2. Repair first when it's reasonable

    Not every problem calls for new equipment. If a repair will keep your system running well, we'll recommend that instead of a replacement.

  3. Equipment that fits your home

    When you do need a new system, we size it for your home, your ductwork, and how hot your part of the valley gets. We don't simply match the old unit's label.

FAQ

Common questions

Why does my furnace start, then shut off after a few seconds?

The most common cause is a dirty or failing flame sensor. If the sensor can't confirm the flame, the furnace shuts the gas off for safety. A clogged filter or a venting problem can cause similar behavior, so we check all three.

Is it normal for my heat pump to blow air that feels cool?

Heat pump air often feels cooler than furnace air, even when it's heating properly. If the air is truly cool, or the house won't reach the thermostat setting, the cause could be low refrigerant, a stuck reversing valve, or a thermostat setup issue.

Do I have to replace my gas furnace because of the new Air District rules?

No. Bay Area Air District appliance rules do not require replacing working equipment. They apply only when an existing furnace fails or is replaced, and the zero-NOx standard for gas furnaces covers units manufactured from 2029 onward.

Can I still get the federal tax credit for a heat pump?

No. The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025, and it isn't available for new installations. You can check BayREN and your local clean energy provider for current incentives.

My furnace smells like burning dust. Is that a problem?

A short burning-dust smell is common the first time a furnace runs after months off. If the smell lasts more than a little while, smells electrical, or keeps coming back, turn the system off and have it checked. If you smell gas, leave the house and call your gas utility or 911 from outside.

Do you serve areas near Campbell?

Yes. Along with Campbell and the 95008 ZIP code, we provide heating repair in Monte Sereno, Los Gatos, Saratoga, Cupertino, and Santa Clara.

Need Heating or Cooling Help in San Jose?

Tell us what your system is doing, or not doing, and we'll set up a visit to find the cause and walk you through your options.

(669) 800-1182
Call (669) 800-1182 Request Service